Asav Keygen [BETTER]
in the seventh step, you configure the asav. this step is straightforward, but it does require some planning. the first question to consider is whether you can use the same virtual serial port that you use to connect to the asav to connect to the vmware workstation virtual machine.
the following commands demonstrate how to set up a serial connection: to setup the serial connection, run the following command:
# atuxon /dev/ttys0 the asav now has a serial connection, which you can use to connect to the appliance using the cisco adaptive security appliance cli client.
# atuxstartup -s asav keygen this will create a serial port. this serial port will be used by the asav for cli access. you may also want to give the asav full permissions to this port using the following command:
i also test the new dhcp server on my asav, i configured the new dhcp server on asav, and i configured the new dhcp server on esxi, i find both of them work well. but i wonder what is the difference of the new dhcp server on asav and the new dhcp server on esxi?
this section of asav keygen explains the way to open the web interface on your asav. you can use this as your user name and password. if you have the web interface already on your asav, you can skip this section.
after that you have to configure the web interface on your asav. enter the following commands:asa941(config)# access-list isp line 1 extended permit ip host 192.168.66.5 anyasa941(config)# access-list isp line 2 extended permit ip host 192.5 anyasa941(config)# access-list isp line 3 extended permit ip host 192.5 anyasa941(config)# access-list isp line 4 extended permit ip host 192.5 anyasa941(config)# interface internal-acl ispasa941(config-interface-acl)# interface ispasa941(config-if)# ip address 192.1 255.255.0 192.5asa941(config-if)#